Prized Peony Thank You

The Peony Dies create a beautiful 3D flower. The first step in creating this peony was to crumple the Rich Razzleberry cardstock. Next step was to uncrumple the cardstock and use the 4 flower builder dies from the Peony Dies set to cut out the layers. After all the pieces are cut, they were sponged with Rich Razzleberry ink, then the top edges were brushed with Frost White Shimmer Paint. Then the layers get put together with the center stamen inserted to complete the flower. Below are photos showing each step in building the peony. Apply a strip of liquid glue along the bottom of the layers.

Step 1 Smallest piece slid into next larger piece, line up the curves at the bottom.
Step 2 – slide the pieces from step 1 into the next largest piece.
Step 3 – slide the pieces from Set 2 into the largest layer.
Step 4 – add the stamen to the center slot.

Measurements for layers back to front:

Bottom designer series paper strip 4 1/4″ X 1/2″

Large designer series paper 3 1/2″ X 4″ edges cut with the border die from the Peony Dies

Proud Peacock banner 2 1/2″ x 4 1/2″ top edge cut with the border die, bottom v cut

Pear Pizzazz 2″ square, corners rounded, stamped with Mint Macaron Ink

Old Olive greeting label 2 1/4″ x 3/4″

Product List

Peony Dies

[152701]
$40.00

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s